Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-13
interfaces duplex
Configures duplex mode. In full duplex mode, the interface transmits and receives data simultaneously. In
half duplex mode, the interface can transmit or receive data at a given time. Auto duplex setting causes the
switch to advertise all available duplex modes (half/full/both) for the port during autonegotiation.
interfaces slot[/port[-port2]] duplex {full | half | auto}
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
full Sets interface to full duplex mode.
half Sets interface to half duplex mode.
auto Switch will automatically set both the duplex mode settings to auto-
negotiation.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• You can only configure one slot at a time. Repeat the command to configure additional slots.
• Half duplex mode is not supported on Gigabit modules if a port is detected as Gigabit (1000 Mbps).
• Configuration changes made with the interfaces duplex command on combo ports configured as either
forced copper or preferred copper will only be made on the copper RJ-45 ports and not to the SFP fiber
port. See the interfaces hybrid duplex command for more information.
parameter default
full | half | auto full
To Next Page
Loading...
