Ethernet Port Commands
page 20-26 OmniSwitch 6250 CLI Reference Guide November 2009
interfaces hybrid autoneg
Enables or disables auto negotiation on a single combo port, a range of combo ports, or all combo ports on
a switch.
interfaces slot[/port[-port2]] hybrid {fiber | copper} autoneg {enable | disable | on | off}
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
fiber Specifies that configuration changes will be made to the SFP port(s).
copper Specifies that changes will be made to the copper RJ-45 port(s).
enable Enables auto negotiation.
disable Disables auto negotiation.
on Same as enable.
off Same as disable.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The MIB table and MIB object listed in the “MIB Objects” section below apply to the inactive configured
media only. See the “MIB Objects” section in the interfaces autoneg section for the MIB table and MIB
object for the active configured media.
Examples
-> interfaces 1/25 hybrid copper autoneg disable
-> interfaces 1/25-26 hybrid copper autoneg disable
-> interfaces 1 hybrid copper autoneg disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable | on | off enable
To Next Page
Loading...
