Ethernet Port Commands
page 20-42 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
esmConfTable
esmPortCfgAutoNegotiation
esmPortCfgFlow
esmPortCfgCrossover
esmPortCfgSpeed
esmPortAutoDuplexMode
Crossover In the row labeled CAP, the field displays the valid cross over configu-
rations for the port. In the row label DEF, the field displays the default
cross over settings for the port. The possible values are Auto,
MDI/X/Auto (MDI/MDIX/Auto), or -- (not configurable and/or not
applicable).
Speed In the row labeled CAP, the field displays the valid line speed configu-
rations for the port. In the row label DEF, the field displays the default
line speed settings for the port. The possible values are 10/100, 100,
1G, 10/100/1G, 10G, or Auto.
Duplex In the row labeled CAP, the field displays the valid duplex configura-
tions for the port. In the row label DEF, the field displays the default
duplex settings for the port. The possible values are Full, Full/Half, or
Auto.
interfaces autoneg Enables and disables auto negotiation.
interfaces crossover Configures crossover port settings.
interfaces speed Configures interface speed.
interfaces duplex Configures duplex settings.
show interfaces status Displays interface line settings.
output definitions (continued)
To Next Page
Loading...
