Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-45
show interfaces pause
Displays the flow control pause configuration for the specified interface(s).
show interfaces [slot[/port[-port2]]] pause
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
If a specific slot or slot/port number is not entered with this command, the flow control pause configura-
tion for all switch interfaces is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number (e.g., 3/21) or a range of port numbers (e.g., 3/21-24) to display informa-
tion for a specific port or a range of ports.
• Enter a slot number (e.g., 1) to display information for all ports on a specific slot.
Examples
-> show interfaces pause
Slot/Port Active Wait time(usec) Cfg-Pause Cfg-Cross Hybrid Type
-----------+--------+---------------+--------+-----------+-----------
1/1 - 0 DIS MDIX -
1/2 - 0 DIS MDIX -
1/3 - 0 DIS MDIX -
1/4 - 0 DIS MDIX -
1/5 - 0 DIS MDIX -
1/6 - 0 DIS MDIX -
1/7 - 0 DIS Auto -
1/8 - 0 DIS Auto -
1/9 - 65535 DIS Auto NA
1/10 - 0 DIS Auto -
1/11 - 65535 DIS Auto NA
1/12 - 0 DIS Auto -
1/13 - 0 DIS Auto -
1/14 - 0 DIS Auto -
1/15 - 0 DIS Auto -
1/16 - 0 DIS Auto -
1/17 - 0 DIS Auto -
1/18 - 0 DIS Auto -
1/19 - 0 DIS Auto -
1/20 - 0 DIS Auto -
To Next Page
Loading...
