Ethernet Port Commands
page 20-50 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces counters
Displays interface counters information (e.g., unicast, broadcast, and multi-cast packets received/transmit-
ted).
show interfaces [slot[/port[-port2]]] counters
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, counter information for all slots/ports on the switch is displayed.
• You can display a specific interface by entering the slot and port number (e.g., 3/1).
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number (e.g., 3).
• These counters do not apply to Gigabit Ethernet traffic.
• For combo ports configured as either forced fiber or preferred fiber statistics for the SFP fiber ports and
not the copper RJ-45 ports will be displayed. See the show interfaces hybrid counters command for
more information.
• For combo ports configured as either forced copper or preferred copper statistics for the copper RJ-45
ports and not the SFP fiber port will be displayed. See the show interfaces hybrid counters command
for more information.
To Next Page
Loading...
