Ethernet Port Commands
page 20-56 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces status
Displays interface line settings (e.g., speed and mode).
show interfaces [slot[/port[-port2]]] status
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, line settings for all slots/ports on the switch are displayed.
• You can display a specific interface by entering the slot and port number (e.g., 3/1).
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number (e.g., 3).
• The show interfaces status command displays the status and configuration of the active port in the
first row and the status and configuration of the other port in the following row. See the show inter-
faces hybrid status command for more information.
• The hybrid mode for combo ports is not configurable; combo ports are set to preferred fiber by default.
As a result, the Hybrid Mode field always displays preferred fiber (PF) for all combo ports. For non-
combo ports, the Hybrid Type and Hybrid Mode fields display NA.
To Next Page
Loading...
