Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-57
Examples
The following is an example for a non-combo port:
-> show interfaces 1/2 status
DETECTED CONFIGURED
Slot/ AutoNego Speed Duplex Hybrid Speed Duplex Hybrid Trap
Port (Mbps) Type (Mbps) Mode LinkUpDown
-----+--------+------+------+------+--------+------+------+------
1/2 Enable 1000 Full NA Auto Auto NA -
The following is an example for a combo port:
-> show interfaces 1/25 status
DETECTED CONFIGURED
Slot/ AutoNego Speed Duplex Hybrid Speed Duplex Hybrid Trap
Port (Mbps) Type (Mbps) Mode LinkUpDown
-----+--------+------+------+------+--------+------+------+------
1/25 Enable - - - 1000 Full PF Enable
1/25 Enable - - - 100 Auto PF Enable
FF - ForcedFiber PF - PreferredFiber F - Fiber
FC - ForcedCopper PC - PreferredCopper C - Copper
Release History
Release 6.6.1; command was introduced.
output definitions
Slot/Port Interface slot/port number.
AutoNego Autonegotiation status (Enable/Disable).
Detected Speed Detected line speed (10/100/Auto/1000/10000 Mbps).
Detected Duplex Detected line duplex (Half duplex/Full duplex/Auto).
Detected Hybrid Type The detected combo port type, which can be F (fiber) or C (copper).
Configured Speed Configured line speed (10/100/Auto/1000/10000 Mbps).
Configured Duplex Configured line duplex (Half duplex/Full duplex/Auto).
Configured Hybrid Mode The configured combo port type, which is PF (Preferred Fiber). Con-
figuring the Hybrid Mode is not supported.
Trap Link Up/Down Trap Link status (up/down).
To Next Page
Loading...
