Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-59
show interfaces port
Displays interface port status (up or down).
show interfaces [slot[/port[-port2]]] port
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
The status for all ports is displayed if a specific slot/port value is not specified with this command.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• You can display a specific interface by entering the slot and port number.
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number (e.g., 3).
Examples
-> show interfaces port
Slot/ Admin Link Violations Alias
Port Status Status
-----+----------+---------+----------+-----------------------------------------
1/1 enable down none ""
1/2 enable down none ""
1/3 enable down none ""
1/4 enable down none ""
-> show interfaces 1/24 port
Slot/Port Admin Status Link Status Violations Alias
----------+--------------+------------+----------------+-----------------------
1/24 enable down NETSEC ""
output definitions
Slot/Port Interface slot and port number.
Admin Status Port status (enable/disable).
Link Status Operational status (enable/disable).
To Next Page
Loading...
