Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-63
show interfaces flood rate
Displays interface peak flood rate settings.
show interfaces [slot[/port[-port2]]] flood rate
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, peak rate settings for all slots/ports on the switch are displayed.
• You can display a specific interface by entering the slot and port number.
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number only.
Examples
-> show interfaces flood rate
Slot/Port peak rate(Mb/second) Enable
-----------+----------------------+---------------
02/01 12 Flood only
02/02 47 Flood only
02/03 16 Flood only
02/04 47 Flood only
02/05 47 Flood only
02/06 47 Flood only
02/07 47 Flood only
02/08 47 Flood only
02/09 47 Flood only
02/10 47 Flood only
02/11 47 Flood only
02/12 47 Flood only
02/13 47 Flood only
02/14 47 Flood only
02/15 47 Flood only
02/16 47 Flood only
02/17 47 Flood only
02/18 47 Flood only
To Next Page
Loading...
