Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-67
show interfaces hybrid
Displays general interface information (e.g., hardware, MAC address, input errors, output errors) for
combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper}
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that the status of the SFP port(s) will be displayed.
copper Specifies that the status of the copper RJ-45 port(s) will be displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, information for all slots/ports on the switch is displayed.
• You can display a specific interface by entering the slot and port number (e.g., 3/1).
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number (e.g., 3).
To Next Page
Loading...
