VLAN Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 22-13
Mobile Tag : off,
Source Learning : disabled,
Traffic-Type: ethernet-service Customer SVLAN,
Priority-Map: x->0
output definitions
vlan The numerical VLAN ID. Use the vlan command to create or remove
VLANs.
type The type of VLAN (std, vstk, gvrp, or ipmv).
admin VLAN administrative status: on enables VLAN functions to operate;
off disables VLAN functions without deleting the VLAN. Use the vlan
command to change the VLAN administrative status.
oper VLAN operational status: on (enabled) or off (disabled). The opera-
tional status remains disabled until an active port is assigned to the
VLAN. When the operational status is enabled, then VLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. A VLAN must have an enabled administrative status before it can
become operationally enabled.
stree 1x1 VLAN Spanning Tree status for the VLAN in the 1x1 mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the vlan stp command.
stree flat VLAN Spanning Tree status for the VLAN in the flat mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the vlan stp command.
auth VLAN Authentication status: on (enabled) or off (disabled). Note that
this status is always off because configuring authenticated VLANs is
not supported.
ip IP router interface status: on (IP interface exists for the VLAN) or off
(no IP router interface exists for the VLAN). Use the ip interface com-
mand to define an IP router interface for a VLAN.
mble tag Mobile tagging status: on (enabled); off (disabled). Configured through
the vlan mobile-tag command.
src lrn Source learning status: on (enabled) ; off (disabled). Configured
through the vlan source-learning command.
name The user-defined text description for the VLAN. By default, the VLAN
ID is specified for the VLAN description.
Traffic-Type Type of traffic passing through the VLAN. For example, customer traf-
fic tunneled through a VLAN Stacking Ethernet Service VLAN
(SVLAN). Note this VLAN Stacking is supported only on Metro
switches.
Priority-Map Priority map value set for the VLAN.
To Next Page
Loading...
