Chassis Management and Monitoring Commands
page 2-36 OmniSwitch 6250 CLI Reference Guide November 2009
show cmm
Displays basic hardware and status information for the CMM modules in a standalone switch or the
switches that perform the CMM role running in a stack.
show cmm [number]
Syntax Definitions
number Specifies the CMM slot number within a standalone switch or the CMM
switch number within a stack switches.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If a switch, which performs a secondary CMM role in a stack, the hardware and status information for
both the switches that perform the primary and secondary CMM role will be displayed.
• This command may be used when logged into the switch that performs either the primary or secondary
CMM role in a stack.
Examples
-> show cmm
CMM in slot 1
Model Name: OS6250-24,
Description: 10/100/1000,
Part Number: 902271-10,
Hardware Revision: 002,
Serial Number: E23L9059,
Manufacture Date: JUN 08 2004,
Firmware Version: N/A,
Admin Status: POWER ON,
Operational Status: UP,
Power Consumption: 0,
Power Control Checksum: 0x0,
MAC Address: 00:d0:95:a3:e5:09,
output definitions
Model Name The model name of the switch.
Description A factory-defined description of the associated board (e.g., BBUS
Bridge or PROCESSOR).
Part Number The Alcatel-Lucent part number for the board.
Hardware Revision The hardware revision level for the board.
Serial Number The Alcatel-Lucent serial number for the board.
To Next Page
Loading...
