Chassis Management and Monitoring Commands
page 2-38 OmniSwitch 6250 CLI Reference Guide November 2009
show ni
Displays the basic hardware and status information for Network Interface (NI) modules currently installed
in a standalone switch or in a stack.
show ni [number]
Syntax Definitions
number The slot number for a specific NI module installed in a standalone chas-
sis or the switch number within a stack. If no slot number is specified,
information for all the NI modules is displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command may be used when logged into the switch that performs either the primary or secondary
CMM role in a stack.
Examples
-> show ni 1
Module in slot 1
Model Name: 6250 24 PORT COPPER FE,
Description: 6250 24 PORT COPPER FE,
Part Number: 902734-90,
Hardware Revision: 03,
Serial Number: K2182393,
Manufacture Date: JUN 27 2009,
Firmware Version: ,
Admin Status: POWER ON,
Operational Status: UP,
Power Consumption: 43,
Power Control Checksum: 0x6b36,
CPU Model Type : ARM926 (Rev 1),
MAC Address: 00:e0:b1:c2:ee:89,
ASIC - Physical 1: MV88F6281 Rev 2,
FPGA - Physical 1: 0010/00,
UBOOT Version : n/a,
UBOOT-miniboot Version : 6.6.1.602.R01,
POE SW Version : n/a
To Next Page
Loading...
