Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-5
ethoam domain mhf
Modifies the Message Handling Function (MHF) value of an Ethernet domain.
ethoam domain {domain_name | mac_address} mhf {none | explicit | default}
Syntax Definitions
domain_name Domain name of the Ethernet domain. The length of the domain name
varies depending on its format.
mac_address Specifies the CFM system MAC address.
none Specifies that no MHFs can be created for the specified VLAN ID.
explicit Specifies that MHFs can be created for the specified VLAN ID only on
Bridge ports through which this VLAN ID can pass and only if a Main-
tenance End Point (MEP) is created at a lower MD level.
default Specifies that MHFs can be created on the specified VLAN ID on any
Bridge port through which this VLAN ID can pass.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
The domain_name should be unique amid all those used by or available to the service provider.
Examples
-> ethoam domain esd.alcatel-lucent.com mhf explicit
Release History
Release 6.6.1; command was introduced.
parameter default
none | explicit | default none
To Next Page
Loading...
