Alcatel-Lucent OmniSwitch 6250 - Show Module

Chassis Management and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 2-41
show module
Displays the basic information for either a specified module or all modules installed in a standalone switch
chassis or a stack. Modules include switches performing the primary and secondary CMM roles and
Network Interface (NI) in a stack.
show module [number]
Syntax Definitions
number The slot number for a specific module installed in a standalone switch
chassis or the switch number within a stack. If no slot number is speci-
fied, information for all modules is displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command may be used when logged into the switch that performs either the primary or secondary
CMM role in a stack.
Examples
-> show module
HW Mfg
Slot Part-Number Serial # Rev Date Model Name
-------+--------------+------------+---+-----------+----------------------------
CMM-1 902271-10 E23L9059 002 JUN 08 2004 OS6250-24
NI-1 902271-10 E23L9059 002 JUN 08 2004 OS6250-24
output definitions
Slot The chassis slot position of the module. For detailed slot numbering
information, refer to the “Chassis and Power Supplies” chapter of the
Hardware User Manual. Refer to page 2-36 for additional information
on CMM location callouts.
Part-Number The Alcatel-Lucent part number for the module.
Serial # The Alcatel-Lucent serial number for the module.
Rev The hardware revision level for the module.
Date The date the module was manufactured.
Model Name The descriptive name for the module. For example, OS9-GNI-U24
indicates a twenty four-port Gigabit Ethernet module.