Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-19
ethoam endpoint admin-state
Configures the administrative state of MEP.
ethoam endpoint mep_id domain {domain_name | mac_address} association association_name admin-
state {enable | disable}
Syntax Definitions
mep_id Specifies the Maintenance Association End Point. The valid range is
1–8191.
domain_name Specifies the domain name. For more information on the different
formats of the domain name, refer to ethoam domain command on
page 25-3.
mac_address Specifies the CFM system MAC address.
association_name Association name of the Ethernet OAM Association. Up to 48 (minus
the domain name length) characters may be used.
enable Administratively enables MEP.
disable Administratively disables MEP.
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
The mep_id should be unique amid all those used by or available to the service provider in the specified
MA.
Examples
-> ethoam endpoint 100 domain esd.alcatel-lucent.com association alcatel-sales
admin-state enable
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
