Ethernet OAM Commands
page 25-28 OmniSwitch 6250 CLI Reference Guide November 2009
Usage Guidelines
• This command allows an operator to generate a loopback message for the specified MEP.
• This command signals the MEP that it should transmit loopback messages and detect the presence or
lack of the corresponding loopback reply(s).
• Note that a loopback message is used for fault verification.
• This command is used to validate the connectivity between Maintenance End Points (MEP) and Main-
tenance Intermediate Points (MIP).
Examples
-> ethoam loopback target-macaddress 10:aa:ac:12:12:ad source-endpoint 4 domain
esd.alcatel-lucent.com association alcatel-sales number 10 vlan-priority 4
drop-eligible true
-> ethoam loopback target-endpoint 15 source-endpoint 4 domain esd.alcatel-
lucent.com association alcatel-sales
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
Dot1agCfmMepTransmitLbm
dot1agCfmMepTransmitLbmDestMacAddress
dot1agCfmMepTransmitLbmDestMepId
dot1agCfmMepTransmitLbmDestlsMepId
dot1agCfmMepTransmitLbmMessages
dot1agCfmMepTransmitLbmDataTlv
dot1agCfmMepTransmitLbmVlanPriority
dot1agCfmMepTransmitLbmVlanDropEnable
dot1agCfmMepTransmitLbmResultOK
show ethoam domain Displays the information of a specified Management Domain con-
figured on the bridge.
To Next Page
Loading...
