Chassis Management and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 2-45
show module status
Displays the basic status information for either a specified module or all modules installed in a standalone
switch chassis or a stack. Modules include switches performing the primary and secondary CMM roles
and Network Interface (NI) in a stack.
show module status [number]
Syntax Definitions
number The slot number for a specific module installed in a standalone switch
chassis or the switch number within a stack. If no slot number is speci-
fied, status information for all modules is displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command may be used when logged into the switch that performs either as the primary or secondary
CMM role in a stack.
Examples
-> show module status
Operational Firmware
Slot Status Admin-Status Rev MAC
------+-------------+------------+---------+-----------------
CMM-1 UP POWER ON N/A 00:d0:95:a3:e5:09
NI-1 UP POWER ON N/A 00:d0:95:a3:e5:0b
output definitions
Slot The chassis slot position of the module. For detailed slot numbering
information, refer to the “Chassis and Power Supplies” chapter of the
Hardware User Guide. Refer to page 2-36 for additional information
on CMM callouts.
Operational Status The operational status of the module. Options include UP or DOWN.
For NI and secondary CMM modules, the operational status can be
DOWN while the power status is on, indicating a possible software
issue.
Admin-Status The current power status of the module. Options include POWER ON
or POWER OFF.
To Next Page
Loading...
