Chassis Management and Monitoring Commands
page 2-46 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
Firmware Rev The firmware version for module’s ASICs.
MAC For the CMM, the base chassis MAC address is displayed. For detailed
information on this base chassis MAC address, refer to the “Managing
MAC Addresses and Ranges” chapter of the OmniSwitch 6250 Switch
Management Guide. For NI modules, the MAC address for the corre-
sponding NI is displayed.
show module Displays the basic information for either a specified module or all the
modules installed in the chassis.
show module long Displays the detailed information for either a specified module or all the
modules installed in the chassis.
output definitions (continued)
To Next Page
Loading...
