Alcatel-Lucent OmniSwitch 6250 - Page 996

LINK OAM Commands
page 26-28 OmniSwitch 6250 CLI Reference Guide November 2009
1/4 disabled active activeSendLocal noLoopback
1/5 disabled active activeSendLocal noLoopback
-> show efm-oam port 1/1-3 enabled
Port Mode Operational Status Loopback Status
-------+----------------+---------+-------------------+----------------
1/1 active operational remoteLoopback
1/3 passive activeSendLocal noLoopback
-> show efm-oam port enabled
Port Mode Operational Status Loopback Status
---------+--------+-------------------+----------------
1/1 active activeSendLocal remoteLoopback
1/3 passive activeSendLocal noLoopback
1/7 passive activeSendLocal noLoopback
-> show efm-oam port disabled
Port Mode Operational Status Loopback Status
---------+--------+-------------------+----------------
1/2 active activeSendLocal noLoopback
1/4 passive activeSendLocal noLoopback
1/5 active activeSendLocal noLoopback
-> show efm-oam port enabled passive
Port Operational Status Loopback Status
---------+--------+-------------------+----------------
1/3 activeSendLocal noLoopback
1/7 activeSendLocal noLoopback
-> show efm-oam port active
Port EFM-OAM Status Operational Status Loopback Status
-------+----------------+---------------------+-------+----------------
1/1 enabled activeSendLocal remoteLoopback
1/2 disabled activeSendLocal noLoopback
1/3 enabled activeSendLocal noLoopback
1/4 disabled activeSendLocal noLoopback
1/5 disabled activeSendLocal noLoopback
1/6 disabled activeSendLocal noLoopback
1/7 disabled activeSendLocal noLoopback
Output fields are described here:
output definitions
Port Displays the slot/port number.
EFM-OAM Status The state of the EFM-OAM. LINK OAM instance can have any of the
following status.
• Enabled : Specifies that the LINK OAM is disabled on the
interface.
• Disabled : Specifies that the LINK OAM is disabled on the
interface.