Using the CLI Application Example
OmniSwitch 6250/6450 Switch Management Guide May 2012 page 6-25
Application Example
Using a Wildcard to Filter Table Information
The wildcard character allows you to substitute the asterisk (*) character for text patterns while using the
filter mode.
Note. Type the wildcard character in front of and after the filter text pattern unless the text pattern appears
alone on a table row.
In this example, the show snmp mib family command is used because it displays a long table of MIB
information. This example uses the filter option to display only those lines containing the “vlan” character
pattern.
1 Use the more command to set the number of displayed lines to 10 and to enable the more mode.
-> more size 10
-> more
To verify your settings, enter the following:
-> show more
The more feature is enabled and the number of line is set to 10
2 Enter the show snmp mib family command. Ten lines of information are displayed. The switch is now
in the More? mode as indicated at the bottom of the screen.
-> show snmp mib family
MIP ID MIB TABLE NAME FAMILY
-------+----------------------------------------+---------------------
6145 esmConfTrap NO SNMP ACCESS
6146 alcetherStatsTable interface
6147 esmConfTable interface
6148 ifJackTable interface
7169 dot1qPortVlanTable 802.1Q
7170 qAggregateVlanTable 802.1Q
7171 qPortVlanTable 802.1Q
More? [next screen <sp>, next line <cr>, filter pattern </>, quit <q>]
3 Type the filter pattern “/” command and the following message automatically appears.
Enter filter pattern:
Enter the desired text pattern, in this case “*vlan*”, at the prompt. Remember to type the text exactly as it
would appear in the CLI table and to type the asterisk (*) character before and after the text. The More?
mode prompt automatically re-appears.
Enter filter pattern: *vlan*
More? [next screen <sp>*, next line <cr>*, filter pattern </>*, quit <q>]
To Next Page
Loading...
