Using the CLI Verifying CLI Usage
OmniSwitch 6250/6450 Switch Management Guide May 2012 page 6-27
Verifying CLI Usage
To display information about CLI commands and the configuration status of your switch, use the show
commands listed here:
For more information about the resulting displays from these commands, see the OmniSwitch 6250/6450
CLI Reference Guide. Additional information can also be found in “Using “Show” Commands” on
page 6-5.
show session config Displays session manager configuration information (for example,
default prompt, banner file name, and inactivity timer).
show alias Lists all current commands defined by the use of the alias CLI
command.
show prefix Shows the command prefix (if any) currently stored by the CLI. Prefixes
are stored for command families that support the prefix recognition
feature.
show history Displays commands you have recently issued to the switch. The
commands are displayed in a numbered list.
show more Shows the enable status of the more mode along with the number of
lines specified for the screen display.
To Next Page
Loading...
