Slot Numbering Managing OmniSwitch 6400 Series Stacks
page 6-18 OmniSwitch 6400 Series Hardware Users Guide August 2008
Slot Numbering
For a stack of OmniSwitch 6400 Series switches to operate as a virtual chassis, each module in the stack
must be assigned a unique slot number. To view the current slot assignments for a stack, use the show ni
or show module commands. The slot number is also displayed on the front panel of each switch by the
LED located on the left side of the chassis (refer to “LED Status Indicators” on page 2-20 for more infor-
mation).
There are two ways stacking modules are assigned slot numbers:
• Dynamic slot number assignment by the system software
• Manual slot number assignment by the user
To Next Page
Loading...
