Mounting OS6400 Switches Hot-Swapping Power Supplies
OmniSwitch 6400 Series Hardware Users Guide August 2008 page 3-23
Hot-Swapping a Rack Mounted Power Supply
1 Disconnect the power supply to be hot-swapped from its power source.
2 Loosen the power supply cable of the power-supply to be hot-swapped and disconnect from power
supply.
3 Loosen the captive screw of the power supply to be hot-swapped.
4 Carefully slide the power supply out of the power supply shelf and set aside.
Rack-Mounted Power Supplies
5 Carefully slide the new power supply on to the power supply shelf and secure the power supply to the
shelf using the captive screw.
6 Reconnect the power supply cable of the new power-supply and tighten securely.
7 Re-connect the power supply to its power source.
To Next Page
Loading...
