Configuring STP Port Parameters Configuring Spanning Tree Parameters
page 7-28 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
The following is a summary of Spanning Tree port configuration commands. For more information about
these commands, see the OmniSwitch CLI Reference Guide.
Commands Type Used for ...
bridge slot/port Implicit Configuring the port Spanning Tree status for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
bridge cist slot/port Explicit Configuring the port Spanning Tree status for the single
flat mode instance.
bridge 1x1 slot/port Explicit Configuring the port Spanning Tree status for a VLAN
instance.
bridge slot/port priority Implicit Configuring the port priority value for a VLAN instance
when the 1x1 mode is active or the single Spanning Tree
instance when the flat mode is active.
bridge cist slot/port priority Explicit Configuring the port priority value for the single flat
mode instance.
bridge msti slot/port priority Explicit Configuring the port priority value for a Multiple Span-
ning Tree Instance (MSTI).
bridge 1x1 slot/port priority Explicit Configuring the port priority value for a VLAN instance.
bridge slot/port path cost Implicit Configuring the port path cost value for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
bridge cist slot/port path cost Explicit Configuring the port path cost value for the single flat
mode instance.
bridge msti slot/port path cost Explicit Configuring the port path cost value for a Multiple Span-
ning Tree Instance (MSTI).
bridge 1x1 slot/port path cost Explicit Configuring the port path cost value for a VLAN
instance.
bridge slot/port mode Explicit Configuring the port Spanning Tree mode (dynamic or
manual) for a VLAN instance when the 1x1 mode is
active or the single Spanning Tree instance when the flat
mode is active.
bridge cist slot/port mode Implicit Configuring the port Spanning Tree mode (dynamic or
manual) for the single flat mode instance.
bridge 1x1 slot/port mode Explicit Configuring the port Spanning Tree mode (dynamic or
manual) for a VLAN instance.
bridge slot/port connection Explicit Configuring the port connection type for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
bridge cist slot/port connection Implicit Configuring the port connection type for the single flat
mode instance.
bridge 1x1 slot/port connection Explicit Configuring the port connection type for a VLAN
instance.
To Next Page
Loading...
