Configuring Spanning Tree Parameters Configuring STP Port Parameters
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 7-29
The following sections provide information and procedures for using implicit Spanning Tree port configu-
ration commands and also includes explicit command examples.
Note. When a snapshot is taken of the switch configuration, the explicit form of all Spanning Tree
commands is captured. For example, if the bridge protocol for the flat mode instance was changed from
STP to MSTP, then bridge cist protocol mstp is the command syntax captured to reflect this in the snap-
shot file. In addition, explicit commands are captured for both flat and 1x1 mode configurations.
bridge cist slot/port admin-edge Explicit Configures the connection type for a port or an aggregate
of ports for the flat mode Common and Internal Span-
ning Tree (CIST).
bridge 1x1 slot/port admin-edge Explicit Configures the connection type for a port or an aggregate
of ports for a 1x1 mode VLAN instance.
bridge cist slot/port auto-edge Explicit Configures a port or an aggregate of ports for the flat
mode Common and Internal Spanning Tree (CIST) as an
edge port, automatically.
bridge 1x1 slot/port auto-edge Explicit Configures a port or an aggregate of ports for the 1x1
mode VLAN instance as an edge port, automatically.
bridge cist slot/port restricted-
role
Explicit Configures the restricted role status for a port or an
aggregate of ports for the flat mode Common and Inter-
nal Spanning Tree (CIST) as a restricted role port.
bridge 1x1 slot/port restricted-
role
Explicit Configures a port or an aggregate of ports for the 1x1
mode VLAN instance as a restricted role port.
bridge cist slot/port restricted-
tcn
Explicit Configures a port or an aggregate of ports for the flat
mode Common and Internal Spanning Tree (CIST) to
support the restricted TCN capability.
bridge 1x1 slot/port restricted-
tcn
Explicit Configures a port or an aggregate of ports for the 1x1
mode VLAN instance to support the restricted TCN
capability.
bridge cist txholdcount Explicit Limits the transmission of BPDU through a given port
for the flat mode Common and Internal Spanning Tree
(CIST).
bridge 1x1 txholdcount Explicit Limits the transmission of BPDU through a given port
for the 1x1 mode VLAN instance.
bridge port pvst+ Explicit Configures the type of BPDU to be used on a port when
PVST+ mode is enabled.
Commands Type Used for ...
To Next Page
Loading...
