Quick Steps for Configuring Static Link Aggregation Configuring Static Link Aggregation
page 16-4 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Note. Optional. You can verify your static link aggregation settings with the show linkagg command. For
example:
-> show linkagg 1
Static Aggregate
SNMP Id : 40000001,
Aggregate Number : 1,
SNMP Descriptor : Omnichannel Aggregate Number 1 ref 40000001 size 4,
Name : ,
Admin State : ENABLED,
Operational State : UP,
Aggregate Size : 4,
Number of Selected Ports : 4,
Number of Reserved Ports : 4,
Number of Attached Ports : 4,
Primary Port : 1/1
You can also use the show linkagg port port command to display information on specific ports. See
“Displaying Static Link Aggregation Configuration and Statistics” on page 16-12 for more information on
the show commands.
An example of what these commands look like entered sequentially on the command line on the local
switch:
-> static linkagg 1 size 4
-> static agg 1/1 agg num 1
-> static agg 1/2 agg num 1
-> static agg 1/3 agg num 1
-> static agg 1/4 agg num 1
-> vlan 10 port default 1
And an example of what these commands look like entered sequentially on the command line on the
remote switch:
-> static linkagg 1 size 4
-> static agg 1/9 agg num 1
-> static agg 1/10 agg num 1
-> static agg 1/11 agg num 1
-> static agg 1/12 agg num 1
-> vlan 10 port default 1
To Next Page
Loading...
