Managing Source Learning Sample MAC Address Table Configuration
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 1-3
1 Create VLAN 200, if it does not already exist, using the following command:
-> vlan 200
2 Assign switch ports 2 through 5 on slot 3 to VLAN 200–if they are not already associated with VLAN
200–using the following command:
-> vlan 200 port default 3/2-5
3 Create a static MAC address entry using the following command to assign address 002D95:5BF30E to
port 3/4 associated with VLAN 200 and to specify a permanent management status for the static address:
-> mac-address-table permanent 00:2d:95:5B:F3:0E 3/4 200
4 Change the MAC address aging time to 1200 seconds (the default is 300 seconds) using the following
command:
-> mac-address-table aging-time 1200
Note. Optional. To verify the static MAC address configuration, enter show mac-address-table. For
example:
-> show mac-address-table
Legend: Mac Address: * = address not valid
Vlan Mac Address Type Protocol Operation Interface
------+-------------------+--------------+-----------+------------+-----------
1 00:00:00:00:00:01 learned 0800 bridging 8/1
1 00:d0:95:6a:73:9a learned aaaa0003 bridging 10/23
200 00:2d:95:5b:f3:0e delontimeout 0 bridging 3/4
Total number of Valid MAC addresses above = 3
To verify the new aging time value, enter show mac-address-table aging-time. For example,
-> show mac-address-table aging-time
Mac Address Aging Time (seconds) = 300
To Next Page
Loading...
