Alcatel-Lucent OmniSwitch 6800 Series - Deleting a Sender Port from an IPMVLAN; Creating and Deleting a Receiver Port; Creating a Receiver Port in an IPMVLAN; Deleting a Receiver Port from an IPMVLAN

Configuring IP Multicast VLAN Configuring IPMVLAN
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 33-11
-> vlan svlan 1/49 network-port
-> vlan ipmvlan 1033 sender-port port 1/49
Deleting a Sender Port from an IPMVLAN
To delete a sender port from an IPMVLAN in the Enterprise or VLAN Stacking mode, use the no form of
the vlan ipmvlan sender-port command by entering no vlan ipmvlan followed by the IPMVLAN ID, the
keyword sender-port, and the port number, as shown below:
-> no vlan ipmvlan 1003 sender-port port 1/50
The following command deletes multiple sender ports from an IPMVLAN:
-> no vlan ipmvlan 1003 sender-port port 1/45-48
Creating and Deleting a Receiver Port
The following subsections describe how to create and delete a receiver port in an IPMVLAN with the
vlan ipmvlan receiver-port command.
Creating a Receiver Port in an IPMVLAN
To create a receiver port in an IPMVLAN configured in the Enterprise mode, use the
vlan ipmvlan receiver-port command as shown below:
-> vlan ipmvlan 1003 receiver-port port 1/51
In the VLAN Stacking mode, the port you want to configure as a receiver port should be a VLAN Stack-
ing port (user port).To create a receiver port in an IPMVLAN configured in the VLAN Stacking mode,
use the vlan ipmvlan receiver-port command as shown below:
-> vlan svlan port 1/1 user-customer-port default-svlan 10
-> vlan ipmvlan 1002 receiver-port port 1/1
Deleting a Receiver Port from an IPMVLAN
To delete a receiver port from an IPMVLAN in the Enterprise or VLAN Stacking mode, use the no form
of the vlan ipmvlan receiver-port command by entering no vlan ipmvlan followed by the IPMVLAN
ID, the keyword receiver-port, and the port number, as shown below:
-> no vlan ipmvlan 1003 receiver-port port 1/51
Associating an IPMVLAN with a Customer VLAN
To associate an IPMVLAN with a customer VLAN, use the vlan svlan port translate ipmvlan
command. Note that the port you want to use to associate an IPMVLAN with a customer VLAN should be
a receiver port. Also, the receiver port must be a VLAN Stacking port (user port). For example, the
following series of commands will associate an IPMVLAN with a customer VLAN:
-> vlan svlan port 1/1 user-customer-port default-svlan 10
-> vlan ipmvlan 1002 receiver-port port 1/1
-> vlan svlan port 1/1 translate cvlan 10 ipmvlan 1002