sFlow Diagnosing Switch Problems
page 35-32 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Displaying a sFlow Sampler
The show sflow sampler command is used to display the sampler table.
For example, to view the sFlow sampler table, enter the show sflow sampler command without specify-
ing any additional parameters. A screen similar to the following example will be displayed, as shown
below:
-> show sflow sampler
Instance Interface Receiver Sample-rate Sample-hdr-size
-----------------------------------------------------------------
1 2/ 1 1 2048 128
1 2/ 2 1 2048 128
1 2/ 3 1 2048 128
1 2/ 4 1 2048 128
1 2/ 5 1 2048 128
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
Displaying a sFlow Poller
The show sflow poller command is used to display the poller table.
For example, to view the sFlow poller table, enter the show sflow poller command without specifying any
additional parameters. A screen similar to the following example will be displayed, as shown below:
-> show sflow poller
Instance Interface Receiver Interval
-------------------------------------------
1 2/ 6 1 30
1 2/ 7 1 30
1 2/ 8 1 30
1 2/ 9 1 30
1 2/10 1 30
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
Displaying a sFlow Agent
The show sflow agent command is used to display the receiver table.
For example, to view the sFlow agent table, enter the show sflow agent command without specifying any
additional parameters. A screen similar to the following example will be displayed, as shown below:
-> ip interface loopback0 127.0.0.1
-> show sflow agent
To Next Page
Loading...
