Managing CMM Directory Content CMM Files
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 4-7
Scenario 3: Saving the Working Directory to the Certified Directory
After running the modified configuration settings and checking that there are no problems, the network
administrator decides that the modified configuration settings (stored in the working directory) are
completely reliable. The administrator then decides to save the contents of the working directory to the
certified directory. Once the working directory is saved to the certified directory, the modified configura-
tion file is included in a normal reboot.
Since the working and certified directories are exactly the same, the switch is running from the working
directory.
Running Configuration is Saved to Working, then to the Certified Directory
RWC
RWC
RWC
RWC
1. Switch boots
from certified
directory by using
factory configura-
tion settings.
Since the working
and certified
directories are the
same, it will be
running from the
working direc-
tory.
2. Changes are
made to the run-
ning configura-
tion, stored in the
running configura-
tion, saved to the
working direc-
tory, and then
saved to the certi-
fied directory.
3. Power is inter-
rupted and the
switch goes down.
4. Switch reboots
from certified
directory by using
saved configura-
tion file in the cer-
tified directory.
Since the working
and certified direc-
tories are the same,
it will be running
from the working
directory.
To Next Page
Loading...
