Logging Into the Switch Using FTP
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 2-11
You have to enter a valid user name and password for the host you specified with the ftp6 command, after
which you will get a screen similar to the following display:
Name:Jsmith
331 Password required for Jsmith
Password: *****
230 User Jsmith logged in.
Note. It is mandatory to specify the name of the particular IPv6 interface, if the target has been specified
using the link-local address.
After logging in, you will receive the ftp-> prompt, where you can execute the FTP commands that are
supported on the switch. For further information refer to the OmniSwitch 6850/9000 CLI guide.
Note. You must use the binary mode (bin) to transfer image files via FTP.
To Next Page
Loading...
