Configuring Network Time Protocol (NTP) Verifying NTP Configuration
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 3-13
Verifying NTP Configuration
To display information about the NTP client, use the show commands listed in the following table:
For more information about the resulting displays from these commands, see the “NTP Commands” chap-
ter in the OmniSwitch CLI Reference Guide.
Examples of the show ntp client, show ntp server status, and show ntp client server-list command
outputs are given in the section “NTP Quick Steps” on page 3-3.
show ntp client Displays information about the current client NTP configuration.
show ntp server status Displays the basic server information for a specific NTP server or a list
of NTP servers.
show ntp client server-list Displays a list of the servers with which the NTP client synchronizes.
show ntp keys Displays information about all authentication keys.
To Next Page
Loading...
