Modifying IPMSv6 Parameters Configuring IP Multicast Switching
page 42-36 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
To set the MLD group limit for a VLAN and replace any requests above the limit, use the ipv6 multicast
vlan max-group command as shown below:
-> ipv6 multicast vlan 10 max-group 25 action replace
To set the MLD group limit for a port and drop any requests above the limit, use the ipv6 multicast port
max-group command as shown below:
-> ipv6 multicast port 1/1 max-group 25 action drop
To Next Page
Loading...
