Configuring IP Multicast VLAN Configuring IPMVLAN
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 43-9
Configuring IPMVLAN
This section describes how to use Command Line Interface (CLI) commands to complete the following
configuration tasks:
• Creating and deleting IPMVLAN (see “Creating and Deleting IPMVLAN” on page 43-9).
• Assigning IPv4/IPv6 address to an existing IPMVLAN and removing it (see “Assigning and Deleting
IPv4/IPv6 Address” on page 43-10)
• Assigning and removing the c-tag in an IPMVLAN (see “Assigning and Deleting a Customer VLAN
Tag” on page 43-10).
• Creating and deleting a sender port in an IPMVLAN (see “Creating and Deleting a Sender Port” on
page 43-11).
• Creating and deleting a receiver port in an IPMVLAN (see “Creating and Deleting a Receiver Port” on
page 43-12).
• Configuring a VLAN translation of a CVLAN to an IPMVLAN (see “Associating an IPMVLAN with
a Customer VLAN” on page 43-12).
In addition, a tutorial is provided in “IPMVLAN Application Example” on page 43-13 that shows you
how to use CLI commands to configure a sample network.
Note. See the “IP Multicast VLAN Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation of IPMVLAN CLI commands.
Creating and Deleting IPMVLAN
The following subsections describe how to create and delete an IPMVLAN with the vlan ipmvlan
command.
Note. The Enterprise mode is the default mode of an IP Multicast VLAN.
Creating IPMVLAN
To create an IPMVLAN, use the vlan ipmvlan command as shown below:
-> vlan ipmvlan 1003 name
"multicast vlan"
For example, to create an IPMVLAN in the 1x1 Spanning Tree mode, enter:
-> vlan ipmvlan 1333 1x1 stp enable name “nvlan”
To Next Page
Loading...
