Configuring IP Multicast VLAN IPMVLAN Application Example
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 43-13
IPMVLAN Application Example
The figure below shows a sample IPMVLAN network with three customers A, B, and C, respectively.The
customers are connected to the Ethernet switch requesting multicast data.
.
Example of an IMPVLAN Network
Follow the steps below to configure this network:
Note. All the steps following step 1 (which must be executed first) may be entered in any order.
1 Create an IPMVLAN by entering:
-> vlan ipmvlan 1003 name "multicast vlan"
2 Assign IPv4/IPv6 address to the IPMVLAN by entering:
-> vlan ipmvlan 1003 address 225.0.0.1
3 Create a sender port in the Enterprise mode of IPMVLAN by entering:
-> vlan ipmvlan 1003 sender-port port 1/50
Ethernet Switch
Core Unicast
and
Multicast Router
Customer A
Customer B
Customer C
To Next Page
Loading...
