Configuring the Server Farm Configuring Server Load Balancing
page 44-18 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Adding the Loopback Adapter Driver to a Windows 2000 Server
Follow the steps below to add the Microsoft loopback adapter driver to a Windows 2000 server.
1 Open the Control Panel window by clicking the Start button and then selecting Settings.
2 Double-click the Add/Remove Hardware icon in the Control Panel window.
3 Click the Next button in the Add/Remove Hardware Wizard window.
4 Click the Next button.
5 Select the Add/Troubleshoot a device radio button in the Add/Remove Hardware Wizard window.
6 Click the Next button.
Double-click the “Add/
Remove Hardware” icon.
Click “Next” when
done.
Select the
“Add/Troubleshoot a
device” radio button.
To Next Page
Loading...
