Alcatel-Lucent OmniSwitch 6850-48 - Chapter 47 Configuring Network Security; Network Security Specifications; Network Security Defaults

Network Security Specifications Configuring Network Security
page 47-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Network Security Specifications
Network Security Defaults
RFCs supported Not applicable at this time.
IEEE Standards supported Not applicable at this time.
Platforms Supported OmniSwitch 6850, 6855, and 9000
Maximum number of monitor-
ing-groups
32
Time duration to observe traffic
pattern
5 to 3600 in seconds
Minimum traffic to activate
anomaly detection
1 to 100000
Anomaly sensitivity to deviation 1 to 100
Parameter Description Command Default Value/Comments
Status of anomaly detection netsec group anomaly Disabled
Log status netsec group anomaly Disabled
Trap status netsec group anomaly Disabled
Quarantine status netsec group anomaly Disabled
Time duration to observe traffic
pattern
netsec group anomaly 30 seconds
Anomaly sensitivity to deviation netsec group anomaly 50