Quick Steps for Configuring VPLS Configuring VPLS
page 11-6 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
19 (Optional) Create a Layer 2 port profile to discard GVRP and STP control frames received on access
ports using the configure service l2profile command. For example, the following commands create the
“discard-stp-gvrp” profile and configure the profile to discard stp and gvrp:
-> configure service l2profile discard-stp-gvrp create stp discard
-> configure service l2profile discard-stp-gvrp gvrp discard
Note that new profiles inherit the default settings for processing control packets; the above commands only
change the settings for STP and GVRP in the specified profile.
20 (Optional) Associate the “discard-stp-gvrp” profile with access port 1/4 using the configure service
port l2profile command. For example:
-> configure service port 1/4 l2profile “discard-stp-gvrp”
See “Verifying the VPLS Configuration” on page 11-32 for information about how to display the VPLS
configuration for the switch.
To Next Page
Loading...
