In This Chapter Configuring Spanning Tree Parameters
page 13-2 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
In This Chapter
This chapter provides an overview about how Spanning Tree works and how to configure Spanning Tree
parameters through the Command Line Interface (CLI). CLI commands are used in the configuration
examples; for more details about the syntax of commands, see the OmniSwitch CLI Reference Guide.
Configuration procedures described in this chapter include:
• Selecting the switch Spanning Tree operating mode (flat or 1x1) on page 13-12.
• Configuring Spanning Tree bridge parameters on page 13-17.
• Configuring Spanning Tree port parameters on page 13-26.
• Configuring Ring Rapid Spanning Tree on page 13-39.
• Configuring an example Spanning Tree topology on page 13-40.
To Next Page
Loading...
