Alcatel-Lucent OmniSwitch 6850-48 - Verifying the UDLD Configuration

Configuring UDLD Verifying the UDLD Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 17-9
Verifying the UDLD Configuration
To display UDLD configuration and statistics information, use the show commands listed below:
For more information about the resulting display from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show udld configuration port and show udld statistics
port commands is also given in “Quick Steps for Configuring UDLD” on page 17-3.
show udld configuration Displays the global status of UDLD configuration.
show udld configuration port Displays the configuration information for all UDLD ports or for
a particular UDLD port on the switch.
show udld statistics port Displays the UDLD statistics for a specific port.
show udld neighbor port Displays the UDLD neighbor ports.
show udld status port Displays the UDLD status for all ports or for a specific port.