BFD Application Example Configuring BFD
page 30-30 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
• To verify the configured BFD status on routers, use the show ip bfd-std command. This command
shows the protocols registered for BFS (OSPF in example network) and the parameter values for the
transmit, receive, and echo intervals, the multiplier number, and the operational mode.
• To check the BFD status on all interfaces, use the show ip bfd-std interfaces command. This
command displays the interfaces participating in the BFD sessions, the IP addresses associated with the
interface, and respective BFD session parameters.
• To check the BFD status on an individual interface, use the show ip bfd-std interfaces command
along with the interface name.
• To display information about BFD sessions, use the show ip bfd-std sessions command.
• To check the BFD status at the OSPF protocol level, use the show ip ospf command. This command is
also used to check the general OSPF configuration. For OSPF interfaces, use the show ip ospf inter-
face command.
To Next Page
Loading...
