Quick Steps for Configuring Access Guardian Configuring Access Guardian
page 34-6 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
Captive Portal:
authentication:
pass: default-vlan (default)
fail: block (default)
Device classification policies on 802.1x port 2/48
Supplicant:
authentication:
pass: vlan 500, block
fail: block (default)
Non-Supplicant:
block (default)
Captive Portal:
authentication:
pass: default-vlan (default)
fail: block (default)
To verify the Captive Portal configuration for an 802.1X-enabled port, use the show 802.1x command:
-> show 802.1x 1/13
802.1x configuration for slot 1 port 13:
direction = both,
operational directions = both,
port-control = auto,
quiet-period (seconds) = 60,
tx-period (seconds) = 30,
supp-timeout (seconds) = 30,
server-timeout (seconds) = 30,
max-req = 2,
re-authperiod (seconds) = 3600,
reauthentication = no
Supplicant polling retry count = 2
Captive Portal Session Limit (hrs) = 12
Captive Portal Login Retry Count = 3
To verify the global Captive Portal configuration for the switch, use the show 802.1x auth-server-down
command:
-> show 802.1x captive-portal configuration
802.1x Captive Portal configuration for slot 7 port 11:
Session Limit (hours) = 4,
Login Retry Count = 5,
802.1x Captive Portal configuration for slot 8 port 1:
Session Limit (hours) = 8,
Login Retry Count = 2,
To Next Page
Loading...
