Configuring Access Guardian Configuring Access Guardian Policies
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 34-31
• The order in which parameters are configured determines the order in which they are applied. For
example, the following commands apply Group Mobility rules at different times during the classifica-
tion process:
-> 802.1x 2/12 captive-portal policy authentication pass group-mobility vlan 10
block fail vlan 10 default-vlan
-> 802.1x 2/12 captive-portal policy authentication pass vlan 10 group-mobility
block fail vlan 10 default-vlan
The first command in the above example checks Group Mobility rules first then checks for VLAN 10
next. The second command checks for VLAN 10 first then checks for Group Mobility rules.
• When a policy is specified as a policy to apply when authentication fails, device classification is
restricted to assigning non-supplicant devices to VLANs that are not authenticated VLANs
To Next Page
Loading...
