Configuring Access Guardian Verifying the Access Guardian Configuration
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 page 34-45
Verifying the Access Guardian Configuration
A summary of the show commands used for verifying the Access Guardian configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show 802.1x Displays information about ports configured for 802.1X. Includes Cap-
tive Portal session timeout and login retry parameter values.
show 802.1x auth-server-down Displays global information about the Access Guardian Captive Portal
configuration.
show 802.1x device
classification policies
Displays Access Guardian device classification policies configured for
802.1x-enabled ports.
show aaa user-network-profile Displays the User Network Profile (UNP) configuration for the switch.
show aaa classification-rule Displays the UNP mobile classification rule configuration for the
switch.
show aaa hic Displays the global Host Integrity Check (HIC) configuration for the
switch.
show aaa hic host Displays a list of the learned host MAC addresses and the HIC status for
each host.
show aaa hic server Displays the HIC server configuration for the switch.
show aaa hic allowed Displays the Host Integrity Check (HIC) server exception list.
show aaa authentication 802.1x Displays information about the global 802.1X configuration on the
switch.
show aaa authentication mac Displays a list of RADIUS servers configured for MAC based authenti-
cation.
To Next Page
Loading...
