Mounting OS6855-14 and OS6855-U10 Switches Rack-Mounting OS6855-14 and OS6855-U10 Switches
OmniSwitch 6855 Series Hardware Users Guide March 2009 page 4-11
21 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
flange. Tighten both screws until they are secure.
Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.
22 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws.
Be sure that all screws are securely tightened.
When rack mounting, a clearance of
0.875 inches is recommended above
OS6855-14 and OS6855-U10
switches.
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
To Next Page
Loading...
