Configuring Spanning Tree Parameters Configuring STP Port Parameters
OmniSwitch AOS Release 7 Network Configuration Guide March 2011 page 5-35
Spanning Tree on Link Aggregate Ports
Physical ports that belong to a link aggregate do not participate in the Spanning Tree Algorithm. Instead,
the algorithm is applied to the aggregate logical link (virtual port) that represents a collection of physical
ports.
To enable or disable the Spanning Tree status for a link aggregate, use the spantree vlan or spantree cist
commands described above but specify a link aggregate control (ID) number instead of a slot and port. For
example, the following command disables Spanning Tree for the link aggregate 10 association with
VLAN 755:
-> spantree vlan 755 linkagg 10 disable
For more information about configuring an aggregate of ports, see Chapter 6, “Configuring Static Link
Aggregation,” and Chapter 7, “Configuring Dynamic Link Aggregation.”
To Next Page
Loading...
