In This Chapter Configuring Spanning Tree Parameters
page 5-2 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
In This Chapter
This chapter provides an overview about how Spanning Tree works and how to configure Spanning Tree
parameters through the Command Line Interface (CLI). CLI commands are used in the configuration
examples; for more details about the syntax of commands, see the OmniSwitch CLI Reference Guide.
Configuration procedures described in this chapter include:
• Selecting the Spanning Tree operating mode (flat or per-VLAN) on page 5-20.
• Configuring Spanning Tree bridge parameters on page 5-25.
• Configuring Spanning Tree port parameters on page 5-33.
• Configuring an example Spanning Tree topology on page 5-44.
To Next Page
Loading...
