Alcatel-Lucent OmniTouch 8118 - 3 Using Your Telephone; Making and Receiving Calls

26 June 2012 6
Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
4 Installation of VoWiFi Handsets
This section describes the recommended procedure for installing and configuring VoWiFi
Handsets. There are several ways to install a VoWiFi Handset, but the procedures described here
guarantees simple maintenance of the network.
The WinPDM enables administration of one VoWiFi Handset at the time inserted in a Desktop
Programmer (DP1) connected via USB to the administrator’s computer. See Installation steps in
small VoWiFi Systems using WinPDM.
Installation steps in small VoWiFi Systems using WinPDM
1 Create Numbers.
2 Create one template for all settings in the WinPDM.
See 4.1 Installation without Central Device Management on page 6 for more information.
4.1 Installation without Central Device Management
In a small VoWiFi system, the administration can be handled using only the WinPDM.
The synchronization is in this case not handled automatically by the system when a VoWiFi
Handset’s parameters are changed in the WinPDM. When the parameters have been changed in
WinPDM, each VoWiFi Handset must be placed in the DP1 cradle connected to the
administrator’s computer in order to synchronize the parameters with the VoWiFi Handset.
1 Open the WinPDM.
2 In the Numbers tab, click “New“. The New numbers window is opened.
3 In the Device Type and Parameter version drop-down lists, select the matching device
type and the parameter version for the VoWiFi Handset to be use, respectively.
4 In the Prefix field, enter the numbers’ prefix (if needed).
5 Create a range of numbers by selecting the “Range“ option. Enter the start call number
and the end call number in the fields, respectively.
6 Click “OK”.
7 Create a network settings template (see 4.3.1 Create a template on page 8) with the
following network parameters:
• Network settings
1
(located under Network > Network A, B, C, or D)
8 Create another template (see 4.3.1 Create a template on page 8) with the common
VoWiFi Handset settings applicable to all VoWiFi Handsets (exclude the network
parameters and used security settings). Example of parameters settings:
• VoIP settings
2
(located under VoIP)
• Software TFTP IP address (if any) (located under Device > General)
• Syslog settings
3
(if any) (located under Device > General)
In addition, settings for hiding menu items in the display, certain level of ring signal and
vibrators etc can also be configured.
9 Apply the network settings template to the VoWiFi Handset, see 4.3.2 Apply a Template
to a Handset with a Number on page 8.
10 Apply the common settings template to the VoWiFi Handset, see 4.3.2 Apply a Template
to a Handset with a Number on page 8.
1. All required system settings for the WLAN. For example SSID and Security mode.
2. VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the PBX.
3. The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.