26 June 2012 7
Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
11 Put the VoWiFi Handset in the DP1 cradle.
12 In the Device Wizard window, select “Associate with number“ and press “OK“.
13 Select the VoWiFi Handset to associate with. Press “OK“.
The number and parameter settings saved in the WinPDM will now be synchronized with the
VoWiFi Handset. In addition, the VoWiFi Handset’s Device ID will also be synchronized with
the number in the WinPDM.
If certificates must be used to access a VoWiFi system, also perform the steps 14 - 19.
14 In the Numbers tab, right-click the VoWiFi Handset’s number and select “Edit
certificates“. An Edit certificate window opens.
15 In the Root tab and Client tab, click “Edit“ and select the certificates to import. Click
“Close“.
16 In the Numbers tab, right-click the VoWiFi Handset’s number and select “Edit
parameters“.
17 Select “Network X“ (X represents A, B, C, or D).
18 In the Security mode drop-down list, select “EAP-TLS“.
19 In the EAP client certificate drop-down list, select the client certificate to be used. Click
“OK“.
20 Remove the VoWiFi Handset when synchronisation is finished.
Repeat the steps 11-13, 20 (if needed, perform the steps 14-19) for all VoWiFi Handsets.
4.2 Installation using the Handset’s Admin Menu
It is possible to install a VoWiFi Handset using its Admin menu. This is useful when no
WinPDM is available and the VoWiFi Handset needs to be installed quickly.
Note: It is only possible to configure the basic settings via the Admin menu.
1 There are two options to access the Admin menu:
• If the VoWiFi Handset has been factory reset or not been configured; in idle mode,
enter 40022.
• If the VoWiFi Handset has been configured; press “Menu“, select “Settings“ and
enter 40022.
2 Set the following parameters:
• Device settings (located under Device Info)
• Site survey tool settings (located under Site survey tool)
• Network settings (located under Network setup)
• Syslog settings
1
(if any) (located under Syslog)
• Factory reset
4.3 Configure a Handset with a Template
It is possible to select a VoWiFi Handset in the WinPDM and directly change one or more
configuration parameters. By using a template, the same configuration can easily be applied to
many VoWiFi Handsets simultaneously. Templates are also an efficient way to give good
control over which changes that are applied to each VoWiFi Handset.
Templates enables configuration of all aspects of a VoWiFi Handset from sound volume to
keypad shortcuts.
1. The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.
To Next Page
Loading...
